The so-called part processing accuracy refers to the degree of conformity between the actual geometric parameters (such as size, shape and position) of the part and the ideal geometric parameters after processing. The part processing accuracy includes dimensional accuracy, shape accuracy and position accuracy. Therefore, we must pay attention to the precision of the mechanics when using the mould to manufacture the parts.
l. Processing of glue tank: In the past, the processing quality of the glue tank of the oil seal mould has not been paid enough attention. The glue tank is often processed too far from the cavity or the size is not easy to control, which makes it difficult to trim the product and the product is not beautiful. Two open oil seal moulds have been improved for these problems.The size of the inner end of the triangular flow tank is the same as the outer diameter of the product (zero to zero). When the oil seal is compression-moulded, the excess flash is cut off, which not only simplifies the trimming process, but also improves the appearance quality of the product. Because the glue tank and the outer diameter of the cavity are on different modules, the size does not interfere, and its accuracy is easy to ensure.
2. the upper mould and the upper mould core 1 processing: the upper mould and the upper mould core 1 is a tapered fit. In the past, the method of research and matching was used, and the contact rate was required to be above 80%. This traditional processing method is not only difficult, but also consumes a lot of man-hours. It is still difficult to achieve the ideal effect without flash. The new structure mould is processed with a slightly smaller inclination angle of the tapered hole than the inclination angle of the tapered shaft, so that the upper mould and the upper mould core are always tightly attached to each other at the parting surface b, in a gapless fit. State, so the product does not have flash. And the mould manufacturing processability is improved.
3. Compression of the upper mould core 1 and the upper mould core 2: The compression of the upper mould core 1 and the upper mould core 2 is the key to ensure the size and accuracy of the oil seal vice lip. The flash at the auxiliary lip of the three-open oil seal mould has a great influence on the appearance quality of the auxiliary lip. In the new structure mould, the upper mould core 1 and the upper mould core 2 adopt an interference fit. After the individual processing, the upper mould core 2 is pressed into one body by the thermal expansion method, and then the upper mould core 2 is tightly pulled by the upper fastening screws, effectively Prevent the two cores from loosening at the secondary lip.
4. the connection between each cavity mould: the connection between each single cavity mould and the joint plate must have a certain amount of floating to ensure that the mould opening and closing is flexible and accurate. Generally, the gap between the single mode and the interconnecting board is controlled at 0.50 to 1.0rnm. Excessive clearance can easily cause the development of new structure moulds with off-axis oil seals when the mould is used. The development of moulds will increase too much, which will increase the wear of the mould and affect the service life of the mould. .