In the storage of equipment, it should be noted that the workshop mechanics need to remove the outer packaging after receiving it, remove the anti-rust oil and then clean and disinfect it with 95% ethanol before storing it in the mould for storage. The sheet placement area is clearly marked.
Before using the tablet press mould, it should be checked whether the specifications of the mould using the health care product tableting machine match the specifications of the required specifications.
Before the mould is installed, use a clean cloth to wipe, and then wipe with 75% ethanol. After the ethanol is evaporated, install it again. The industry reminds that during the installation process, it should pay attention to check whether the punch and the die are in agreement, pay attention to light handling, and pay attention to the old and new moulds should not be mixed. When mixing, the control and influence on the difference of the weight should be evaluated or tested.
After the use of the health care product tableting machine mould, it should be sent back to the mould management room and cleaned in time. When cleaning, use 95% ethanol. The cleaning process should pay attention to check whether the mould is damaged or not. If there is damage, pick it up in time, repair it, and repair it. The reporter workshop mechanics evaluated and scrapped and registered.
If the cleaned mould is not used for a long time, it should be coated with a layer of anti-rust oil. When storing, it should be placed according to the model and the type of sheet, and there is obvious indication.
The industry recommends that the storage process should ensure the temperature and humidity of the room to avoid rusting of the mould of the health care product. If the humidity of the room is too high, the dehumidifier can be turned on to keep it dry, keep the mould clean and dry, and the mould should not be stored except the mould. Any item.
