Things To Check Before Injection Molding
1. The mold length must be less than the spacing of the column to put the mold in smoothly. If the mold length is greater
October 7, 2024
No Comments
/
Blog Post
Analysis of the reasons for uneven shrinkage of injection molded parts
If the plastic part shrinks unevenly, it often causes uneven distribution of internal stress. If this stress exceeds the rigidity of the plastic part, it
September 29, 2024
No Comments
Four tips to improve the precision of thin-wall injection molding
Four tips to improve the precision of thin-wall injection molding The application range of plastic parts is becoming more and more extensive, from simple tableware
September 21, 2024
No Comments
Injection Molding Machine Mold Clamping Parameter Setting
Start mold closing clamping 1.Starting mold clamping pressure: The initial setting value is 25. When the pressure is too low and the speed is too
September 16, 2024
No Comments
Understanding the material processing characteristics of nylon
Nylon products are strong and wear-resistant. They will fade if left outside for a long time. When ignited with an open flame, the flame is
September 9, 2024
No Comments
Industrial
Several aspects that need attention to reduce the wear of screw and barrel of injection molding machine and extend life of injection mold
The screw and barrel of the injection molding machine works for a long time under high temperature, high pressure, high mechanical torque and high friction
August 31, 2024
No Comments