Industrial

If the fluidity of the plastic is too large, or if too much lubricant is added, the pressure, speed, temperature, etc. should be properly reduced to reduce the amount of lubricant used. If necessary, a plastic with low fluidity should be used. 1.processing, adjustment: a.The set temperature, pressure, and speed are too high. Subsection injection […]

One of the easiest ways to prepare a variety of delicious foods, even whole foods, is with a basket mould. These two types of moulds are very versatile and are used to create many different types of delicious sweets or used as a quick and easy way to drain the last curls from a baby’s

With extensive food service industry experience and superb knowledge, are you manufacturing different plastic food container moulds? If yes, then you can also increase your production line capacity and improve your customer satisfaction. Plastic moulds play a major role in food service industry. Food service industry is expanding worldwide due to the rise in demand of

Defects visible on the surface of injection moulded articles include dark spots, gloss differences, or fogging areas, and surface wrinkling or what is known as orange peel. Usually these defects occur near the gate or behind the sharp corners of the gate area. Starting from the two aspects of the mould and the moulding process,

In this modern era where production processes have become complex and varied, Auto Moulds have become a necessary part of the process. Auto Part Mould companies provide a range of services to meet the diverse requirements of manufacturing industries dealing in almost all types of vehicle parts. These Auto Mould companies have experienced Auto Part Mould designers

Dark spots not only occur at the gate, but also often appear after the sharp corners of the article are formed. For example, sharp corner surfaces of articles are generally very smooth, but very gray and rough behind it. This is also due to the excessive flow rate and injection speed causing the cooling surface

When using plastic injection moulding (PIM), it is important to control heat. Most injection moulds are made from cooling channels that are drilled or milled from a steel block. Cold water flows through these channels to cool the core and draw heat away from the plastic. Traditionally, these paths have been made by drilling straight

The demand for small and light parts has made thin-wall injection moulding the most demanding performance of injection moulding machines. “Thin wall” is usually defined by lightweight electronic parts with a wall thickness of less than 1 mm. For large automotive parts, the “thin wall” can be 2mm. In summary, thin-walled products require changes in

As for the injection volume, the large diameter barrel is often too large. The recommended injection volume is 40% to 70% of the barrel capacity. The total moulding cycle of thin-walled products is greatly shortened, and it is possible to reduce the minimum injection volume to 20 barrel capacity. %~30%. The user must be very

As the plastic flows through the injection moulding machine and the different parts of the mould, the pressure acting on the leading edge of the plastic flow is lost due to the effects of drag and friction. In addition, as the plastic contacts the mould wall, it begins to cool, increasing the viscosity of the